BAL ACCU-Slide cable standoffs determine how the cables enter and leave the jamb and where a room stops during travel. The G4 Econo, Hybrid and ABS systems use different outside brackets, while several inside bracket shapes also exist. Match the installed part and mechanism label before replacing or repositioning a bracket.
See related replacement parts
Compare these product photos and part numbers with your existing component. Open any item to check its full listing before ordering.
Inside and outside standoff bracket numbers
| BAL system | Part numbers | Description |
|---|---|---|
| G4 Econo | P854757 / P854750 | Outside cable standoff brackets; check dimensions and original shape |
| Hybrid | P854584 / P854749 | Different outside standoff bracket styles; P854584 is listed on NewRVParts |
| ABS | P854182 / P854751 / P854752 | Outside standoffs illustrated for ABS jamb construction |
| Interior brackets | P854129 / P854130 / P854196 | Inside styles illustrated in the manufacturer system sheets |
| Interior reinforcement | 21700148 | Service kit for a damaged inside standoff mounting area, not a complete cable replacement |
Original standoff identification and alignment drawings
Use the model-specific manufacturer sheets to compare outside and inside standoff shapes. The separate placement diagram shows how their distance affects cable length and the room's stopping positions.
G4 Econo bracket designs
Open original manufacturer PDFHybrid bracket designs
Open original manufacturer PDFABS bracket designs
Open original manufacturer PDFRoom depth and bracket placement
Open original manufacturer PDFOn a phone, open the manufacturer PDFs separately to enlarge the drawings and component labels.
Measure between the inside and outside brackets
BAL defines slide-room travel depth using the distance between the interior and exterior standoff brackets. Their locations determine the end points of room travel, and an incorrect distance may leave the cables too long to adjust correctly. Keep brackets vertically aligned and installed in the intended orientation.
Check cable-to-jamb alignment
For interior standoff alignment, BAL's procedure positions the room roughly six to eight inches short of full extension. For an exterior standoff, the room is retracted until it is roughly six to eight inches from the seals. The bracket is adjusted so the cable enters the punched jamb opening in a straight line before fasteners are secured.
Open the original BAL standoff alignment procedure (PDF).
For different jamb profiles and mechanism labels, see our G4 Econo, Hybrid and ABS identification guide. For related cable repairs, visit the 22305 cable replacement guide.