Rieco-Titan's four-corner mechanical camper jack uses a bevel-gear crank mechanism, a telescoping jack post and model-specific mounting hardware. This exploded drawing identifies the gear shaft, thrust bearing, washers, bushings and C-clamp hardware so a worn component can be identified by its factory number.
Original manufacturer exploded parts drawing
Compare the source illustration with your installed equipment. Use the full PDF link to enlarge its smaller callouts, wiring terminals and fasteners.
Open the original document to zoom in on the manufacturer illustration.
Open Four-corner jack exploded view and factory parts list (PDF)
Original numbered components
These factory part numbers correspond to the labelled exploded view. An identified service part may not be separately available in the current catalog.
| Rieco-Titan no. | Component |
|---|---|
| 443140 | Outer tube, C-clamp mounting, zinc |
| 443141 | Outer tube, C-clamp mounting, white |
| 443164 | Inner tube assembly |
| 914340 | C-clamps, zinc (3) |
| 914341 | C-clamps, white (3) |
| 993040 | Thrust-bearing washers (2) |
| 993050 | Thrust bearing |
| 993060 | Bottom gear washer |
| 993070 | Gear-drive pins (2) |
| 993084 | Bevelled gears (2) |
| 993090 | Gear shaft |
| 993100 | Side gear washer |
| 993110 | Gearbox cover, zinc |
| 993111 | Gearbox cover, white |
| 993124 | Gearbox cover retaining wire |
| 993130 | Nylon bushings (3) |
| 993150 | Spacer tube |
| 994124 | Plastic crank spool |
| 994134 | End-stop press nut |
| 994334 | Original drawing's crank handle |
Photos of related NewRVParts products
The linked photographs show the actual catalog listings. Complete jacks, control kits, motors and mounting pieces are sold in different configurations; review each listing's contents and original model number before selecting a replacement.
Identify the correct jack or control system
The illustrated version uses a C-clamp mount. The manufacturer also offers fixed-plate mounting, but its own parts sheet directs owners to confirm those part numbers separately. The zinc and white jack tubes and gearbox covers also carry different original numbers.
NewRVParts lists the complete manual C-clamp jack under 44411 and a separate 14334 crank handle. The drawing identifies the original handle as 994334; do not assume those two numbers are an approved supersession without confirming the required handle connection. The 14032 convertible jack set shown below is a related, different configuration, not the identical C-clamp assembly.