Identify replacement parts for the Lippert SlimRack and SlimRack Plus slide-out systems by the complete manufacturer number. The programmable touchpad, controller, and SlimRack Plus end-bracket service kits perform different jobs and are not interchangeable.
Available SlimRack replacement components
The photos below link to NewRVParts product listings. The callout labels come from Lippert component references; products are shown individually rather than as interchangeable replacements.
363984Programmable touchpadManufacturer ref. AB — Operator switch for matching programmable SlimRack controls; not the controller
700157Manual-programmable controllerSeparate Lippert replacement controller — parking-brake input required; match the installed system
2023033860SlimRack Plus Service Kit IManufacturer ref. KIT-A — Notched end brackets with the matching pins, push nuts, bumpers and seal tape
Manufacturer part-number identification
AB identifies the touchpad in the original SlimRack component list. KIT-A and KIT-G are SlimRack Plus end-bracket kit references. Lippert 700157 is a separately listed replacement controller, not the component labeled AI in the original SlimRack drawing.
| Lippert reference | Manufacturer number | Component | Selection detail |
|---|---|---|---|
| AB | 363984 | Programmable touchpad | Operator touchpad used with supported manually programmed SlimRack controller systems; not a controller module |
| Separate replacement (not an AI callout) | 700157 | Manually programmable controller | Motorized-RV controller with parking-brake input; compare the installed wiring and original controller version |
| KIT-A | 2023033860 | SlimRack Plus Service Kit I | Notched brackets, two pins, two push nuts, two bumpers and 12 in. of foam seal tape |
| KIT-G | 2023033861 | SlimRack Plus Service Kit II | Flat-bracket version, identified separately to avoid ordering the wrong end-bracket style |
Original Lippert service documents
Lippert supplies a numbered SlimRack Plus components sheet and separate controller, switch and motor service documentation. Use the complete manufacturer diagrams to check the part numbers and the original assembly rather than selecting by visual similarity alone.
This original drawing distinguishes notched service kit KIT-A from flat-bracket service kit KIT-G.
For controller diagnostics, installation and programming, refer to the Lippert SlimRack technical-documentation centre.
Looking for the other slide-out mechanism? See the Schwintek In-Wall illustrated parts guide, which uses different component references.