The Stromberg Carlson CC-275 Bike Bunk raises a 2-inch bike-rack receiver above a travel trailer's A-frame. Use this original parts breakdown to identify the lower mounting pockets, bent support posts, cross tube, frame backers and installation hardware before checking a replacement.
Original CC-275 exploded parts and installation drawing
Page 2 of the manufacturer's two-page instructions identifies the nine component groups with callout letters A through I. The mounting sequence and trailer-clearance checks are on page 1.
Open the original CC-275 parts diagram and installation manual (PDF)
On a phone, open the PDF in a separate viewer to enlarge the component labels.
Bike Bunk parts by diagram letter
| Callout | Manufacturer number | Component | Quantity |
|---|---|---|---|
| A | 7605-104P | Lower mounting pockets | 2 |
| B | 7605-117 | Frame backer bars | 4 |
| C | PST-1895, PST-1865, PST-1860, PST-1870 | 5/16 × 4 in mounting hardware components | 8 bolts, with matching washers and nuts |
| D | 7605-107P | Bent vertical support posts | 2 |
| E | 7605-175 | Top cross tube with bike-rack receiver | 1 |
| F | CP-1075 | Cross-tube end caps | 2 |
| G | FST-1620 | 1/4 × 3/4 in stop bolts, factory installed | 2 |
| H | FST-2010 | 3/8 × 1 in set screws | 4 |
| I | MPST-2021 / PST-2083 | 3/8 × 2-3/4 in cross-tube hardware | 4 |
Stromberg Carlson also offers a replacement mounting-hardware assortment as part 2275. The manufacturer lists the four major assemblies separately: 7605-104P lower pocket, 7605-107P bent post, 7605-117P backer bar, and 7605-175 cross tube. The original drawing prints 7605-117 on the backer-bar callout, while the replacement catalog uses 7605-117P.
Dimensions to check on the trailer
| Measurement | CC-275 dimension |
|---|---|
| Top of A-frame to top of cross tube | 33½ in |
| Top of A-frame to underside of rack receiver | 29 in |
| Top cross tube length | 37½ in |
| Receiver-tube centre spacing on cross tube | 34¼ in |
| Bent upright tube outside diameter | 1.9 in |
Confirm the clearance before mounting
The CC-275 is intended to hold an RV-approved bicycle rack, not to tow a trailer or carry other hitch loads. The 100 lb limit includes the weight of the chosen bike rack and all bicycles together. Stromberg Carlson does not approve this mounting system for e-bikes or motorcycles.
Before drilling the uprights, check the tow vehicle's turning clearance with the complete rack and bicycles in place, and allow room to reach propane valves and remove tanks when required. The installation instructions place the frame pockets approximately 2–3 inches from the trailer body, with the upper cross tube about 1–2 inches from it. Confirm the positions on your particular trailer.
For an exterior ladder-mounted bike rack, see the LA-102 bicycle and LA-104 chair rack reference. Browse other illustrated equipment in our RV steps, ladders and accessory parts index.
