Not all BAL ACCU-Slide base rollers do the same job. The 854275 is a floor roller, the 22324 is a service roller for the specified 1-inch-height application, and 854303 and 854304 are repair rollers designed to assist different wear-bar heights. Use the factory illustrations to match the existing support arrangement before ordering.
See related replacement parts
Compare these product photos and part numbers with your existing component. Open any item to check its full listing before ordering.
Identify the floor roller or wear-bar repair
Original BAL roller drawings
The parts-identification sheet shows the four roller shapes. The separate repair document illustrates how 854303 and 854304 fit below a damaged wear bar and includes a roller quantity chart based on slide length.
Roller and tracking parts
Open original manufacturer PDFWear-bar roller installation
Open original manufacturer PDFOn a phone, open the manufacturer PDFs separately to enlarge the drawings and component labels.
Before choosing an 854303 or 854304 roller
Measure the height of the existing wear bar—not the inside diameter of the roller. BAL specifies 854303 for a ¾-inch wear bar and 854304 for a ½-inch wear bar. These repair rollers assist the existing wear bar; they are not intended to carry the entire slide-room weight or replace the wear bar itself.
Repair installation details from the factory drawing
For the specified repair, BAL shows the outer rollers near the ends of the slide floor and additional rollers distributed according to the room-width chart. The illustrated installation uses five No. 10 screws per roller, fastened into suitable structural material. The bottom wipe seal may require careful notching, but the wear bar and plastic extrusion must remain intact.
Installation is structural service work; support the slide room safely and follow the complete manufacturer instructions. If the original 854275 roller cannot be accessed without removing the room, compare the 22324 service assembly with the exact installed roller geometry before proceeding.
Slide-out tracking roller and guide
Older BAL diagrams identify 854599 as a slide-room tracking roller. The current G4 Econo reference identifies the 10800036 tracking guide as its replacement. These tracking pieces are different from the 854275 base roller and the 854303/854304 wear-bar repair rollers. Compare the original tracking arrangement and mechanism generation when selecting a replacement.
If your room uses a drop-down flush-floor system, use our flush-floor compression roller and block guide instead. For G4, Hybrid and ABS mechanism identification, see BAL ACCU-Slide system and jamb diagrams.