The D2102 kit supplies two steel front frame-mounted truck camper tie-downs for certain Dodge/Ram pickups. Its receiver brackets and removable inserts provide front camper attachment points without using the truck bed or bumper as the primary anchor.
See the D2102 tie-down pair
These photos are taken from the NewRVParts listing for the exact D2102 kit. Select a photo to view the product details.
Front tie-down assembly and included pieces
The front kit has a frame receiver on each side and a removable insert at each location. The following is a component identification guide, not a substitute for the factory's vehicle-specific installation drawing.
| Component | Quantity | Purpose |
|---|---|---|
| Left front frame-mounted bracket / receiver | 1 | Bolts to the prescribed driver-side truck frame location |
| Right front frame-mounted bracket / receiver | 1 | Bolts to the corresponding passenger-side frame location |
| Removable steel tie-down inserts | 2 | Slide into the fixed receivers to provide camper attachment points |
| Retaining pins and clips | 2 sets | Secure the removable inserts in their receivers |
| Vehicle-specific installation hardware | Supplied kit | Bolts, nuts, washers and spacers as specified for the exact vehicle kit |
| Original fitting instructions | Supplied kit | Manufacturer illustrations, fastener arrangement and torque procedure |
How the camper is secured
Connection path for identification only; brackets, clearances and routing depend on the exact truck.
D2102 Dodge/Ram configuration requirements
- TorkLift lists D2102 for selected 2003–2009 Dodge/Ram 2500 and 3500 four-wheel-drive trucks with 6.5-foot beds.
- The maker also identifies specific 2006–2008 Ram 1500 Mega Cab 4WD gas-engine configurations; do not extend this to all 1500 body styles.
- Match the exact year, cab, 4WD drivetrain, bed and powertrain in the maker's fit finder before ordering. The D2102 application is not a universal Ram front bracket.
Mounting and inspection
Position each bracket on the designated front truck frame mounting points as shown in the official D2102 instructions. The inserts must fully engage the receivers and be secured by pins/clips. Avoid guessing fastener locations, spacer order or torque from a different Ram kit.
Complete the camper tie-down system
Front brackets alone do not secure all four camper corners. These separately listed products may be useful after selecting the correct rear brackets and measuring the required turnbuckle range.
S9700 — TorkLift removable tie-down insert lock setFour keyed-alike locks for suitable TorkLift receiver inserts; not included
S9522 — TorkLift Original FastGun long turnbuckles, pairTwo long-range spring-loaded turnbuckles, 25–43 inches; sold separately
S9000 — TorkLift Basic SpringLoad kitSpring-loaded turnbuckle components for two tie-down connections; sold separately
Manufacturer fitting instructions
TorkLift provides original application, mounting and service information for this part. Use the exact printed instruction sheet shipped with the kit for its mounting diagrams, bolt placement and torque values.
View the TorkLift D2102 manufacturer information