T-H Marine Outboard Jack Plates: ATLAS vs Micro & Mini-Jacker

Choose the correct outboard jack-plate design

Simplified design silhouettes, not scaled drawings or drilling templates. Use the manufacturer's installation layout for mount points.

ATLAS and Mini-Jacker model comparison chart

Motor limits are manufacturer ratings for the identified product family; they do not establish suitability for a specific boat or transom. Accessory rows are not outboard mounting plates.

Before selecting an outboard jack plate

1. Confirm motor horsepower and dry weight against both manufacturer limits; account for the boat transom and manufacturer installation requirements.
2. Determine whether the installation requires hydraulic vertical adjustment or a fixed clamp-on offset.
3. Measure setback, transom clearance and the outboard bracket rather than matching the visible plate width alone.
4. Do not treat the FAGK-2-DP digital gauge as universal: it is listed for 6-, 10-, 12- and 14-inch ATLAS plates, not 4-/8-inch or Micro-Jacker models; verify the required spacer.
5. Check motor lifting and mounting hardware separately. T-H Marine notes standard ATLAS mounting bolts are not included; follow the exact installation instructions.

Shop exact ATLAS and Mini-Jacker parts

Use each exact part number to open the product listing and confirm the chosen configuration.

Full-size black ATLAS hydraulic jack plates

These standard black ATLAS versions have 10- and 12-inch setbacks and internally mounted hydraulics. Their mounting location must be verified.

T-H Marine AHJ-10V-B-DP — 10-inch hydraulic setbackThe black ATLAS standard-duty jack plate moves the outboard hydraulically, with pump and reservoir integrated into the jack-plate assembly. This MPN is the 10-inch setback version.View part and availability

T-H Marine AHJ-12V-B-DP — 12-inch hydraulic setbackStandard black ATLAS hydraulic model with 12-inch setback. Increased setback alters the outboard's position relative to the transom; choose it only for a suitable boat and motor setup.View part and availability

Compact ATLAS Micro-Jacker

The four-inch-setback powered Micro-Jacker is intended for much smaller outboards than a standard ATLAS plate.

T-H Marine AHJM-4-DP — Compact hydraulic jack plateA compact self-contained hydraulic jack plate for compatible small outboards, limited to 115 hp and 425 lb. The Micro-Jacker body is smaller than the full-size ATLAS system.View part and availability

Clamp-on Mini-Jacker bracket

The MJ-1-DP is a small cast-aluminum offset bracket with no hydraulic motor.

T-H Marine MJ-1-DP — Small clamp-on outboard bracketCast-aluminum Mini-Jacker bracket for specified clamp-mounted small outboards. It has a four-inch setback and three-inch fixed vertical offset, without hydraulic height adjustment.View part and availability

Digital position gauge and remote switch

FAGK-2-DP and TTC-1-DP are separate components; verify the supported jack plate and original wiring.

T-H Marine FAGK-2-DP — Digital jack-plate height displayATLAS LED position-gauge kit for 6-, 10-, 12- and 14-inch ATLAS models, with black bezel. It is not the gauge specified for 4- or 8-inch plates and does not fit the Micro-Jacker. Verify the required spacer.View part and availability

T-H Marine TTC-1-DP — Remote push-button controlWeatherproof remote push-button control with an 18-inch pigtail. Used for compatible trim or hydraulic jack-plate controls; confirm the electrical system, switching and protection before installing.View part and availability