The Go Power GP-BMK-25 (manufacturer part 82958) is a standalone RV battery monitor with its own wired display and a 500A current-measurement shunt. This reference identifies its negative-side connections, included components and alternatives so you can select the correct type of monitoring system.
Where the BMK-25 shunt connects
The battery side of the shunt is marked B−, and the system side P−. For complete current measurement, every load and charging source must return through P− rather than attaching directly to battery negative.
GP-BMK-25 component identification
The monitor is a complete wired battery-measurement package. It combines a display, an external current shunt and a fused positive-sense connection. It does not charge the battery or replace inverter overcurrent protection.
| Included component | What it does |
|---|---|
| GP-BMK-25 display | Backlit flush-mount screen for state of charge, voltage, current, remaining capacity and time estimates |
| 500A/50mV shunt | Installs on battery-negative circuit between battery (B−) and system returns (P−) |
| Fused B+ sense lead | Connects battery positive to the shunt's low-current B+ terminal, using the specified protection |
| Shielded display cable | Links the shunt and remote display; follow the included kit's actual cable length |
| Shunt mounting bracket | Holds the current-measurement shunt securely near the battery |
After installation, enter the battery bank's capacity and synchronize the state-of-charge reading according to Go Power's instructions. Supported battery types include lithium, AGM, gel and flooded lead-acid. The display can also show an additional battery's voltage where configured.
BMK-25 versus PowerTrak RV-C
PowerTrak 84025 is not a plug-in replacement screen for the GP-BMK-25. PowerTrak uses an RV-C communications network, while this kit uses its own separate shunt-to-display cable. Choose the system you actually have.
Exact-number monitor products
The following catalog cards include the standalone GP-BMK-25, the separate PowerTrak network system, and a Bluetooth-shunt alternative. These are different products, not interchangeable components.



Go Power original wiring illustration
The manufacturer manual includes the actual battery, shunt, solar controller and inverter wiring view under Installation — Wiring Diagram. Follow that drawing and the supplied wiring instructions for connection details and mounting.
View the factory GP-BMK-25 wiring drawing (manual PDF) · Go Power GP-BMK-25 specifications
